DIN301 Two zone Temperature Controller

The wine fridges are expensive but you can use our  Mini Digital Temperature Controller Thermostat for converting any chest or freezer into accurate, chip and energy saver wine fridge.

One small wine fridge is so expensive and also can easily consume 20 times more power. Wine Fridges are not energy efficient appliances as the insulation in the linings of the casing walls is kept to a minimum and they tend to run a lot and waste power, typical Compressor motor or Thermocouple run times for Wine Fridges can be around 30 to 60 minutes an hour. But Freezer Cabinet Insulation is approximate 3 times thicker than Wine Refrigerator Cabinets and the Evaporator COLD PLATE on a Freezer is much more energy efficient than any wine fridge. Every time you open a Chest Freezer Lid the cold air stays inside rather than spilling out every time you open a Wine Fridge Door. Converted Chest Freezers make the most Energy Efficient Fridges.

So you can easily convert chest or upright freezer to wine fridge with our digital temperature controller. You can control and monitor the wine fridge very accurate with 2 sensors or even control 2 fridge at the same time.

  Wire this controller and your  freezer into the outlet cord, place the sensor in the area to be controlled and program easily this temperature controller. This thermostat simply turns off the freezer when it reaches the specified temperature. So, save energy and your money and also it will always Defrost Correctly and will give the Fridge Compressor motor ample off Cycle rest Period for Longer Compressor life due to adjustable differential value and delay parameters on your temp controller.

This mini Temperature Controller is an excellent, reliable, accurate and convenient multifunction device when you need to control the temperature precisely and constantly. It’s suitable for all equipment which need to control one zone or two zone (separately) for heating or cooling mode.

It is an ideal solution for a wide range of professional applications to automatically control temperatures of up to -50 to 120 °C. It comes with two temperature sensors and manual.

Features:

2 relay and 2 sensors with 2 independent zones temperature controller.

2 zones (2 Heating mode, 2 Cooling mode or 1 Heating and 1 Cooling).

2 color display (red and blue) for each zone.

Control temperature by setting the start and stop temperature setting value.

High and Low Alarm function (buzzer and flash alarm).

Refrigerating control output delay protection for Out1 and Out2.

Temperature calibration for each sensor.

Setting memory and factory default setting option.

Technical Parameters:

Temperature measuring range: -50-120

Accuracy: 0.1 Celsius

Power consumption< 3W

Sensors: Two NTC 10K with 1m wire length

Power supply: AC 100-240V 

Output: 2 outputs with 10 Amp load 

2 Temperature sensors Specification

• Measurement range: -50  to 120°C
• Cable length (L): 3 ft (1m)
• Sensing tip length x diameter : 20mmx4mm
• Sensor type: Water proof Negative Temperature Coefficient NTC sensor

One Set Included

• 1 x Mini-Temperature Controller
• 2 x Water Proof Temperature sensor probe with 3m cable
• 1 x Instruction Manual and wiring diagram

 Wiring and Manual