This plug and play PID Programmable Ramp and Soak (60 segments) temperature controller with Alarm function and Ceramic thermocouple, has a wide range of applications in controlling the temperature of Kilns, Ovens, Furnaces, pottery, Glass, Annealing, ....

(for loading current up to 20 Amp) . This is an inexpensive and heavy duty plug and play controller box.

Features & Specifications:

· Its heavy duty kiln thermocouple can measure very high temperatures up to 2372 °F (1300 °C).

· To operate, you only need to plug the heater to the socket wire of the controller at the back, drop the sensor into the Kiln, turn on the power of controller and adjust it to your own requirements.

· 20 Amp Maximum current

· Heavy duty input and output plug and socket wire

· Equipped with circuit breaker switch 20 Amp (instead of short life fuse)

· Equipped with Buzzer and flash Alarm for passing the temperature range and thermocouple failure

· Temperature controller features:

- Configurable between Fahrenheit and Celsius

- 30 Ramps and 30 Soaks and time can configurable between minute and second

- Equipped with differential gap, decimal point for all input, Auto tuning (with learning stop or start), alarm output configurable

with 8 different options, system function (heating or cooling),......

Temperature controller specification:

Available Segments	Up to 60 segments available for a program
Detective Temperature Range	-200 to 1800 °C (depends on input type)
Patterns	Be able to program different patterns with different segments
Input	Thermocouple: (K,S,E,J,T,B,N) RTD: (Cu50, PT100) Linear Voltage and current:0-5V,1-5V,0-1V,0-100mV,0-20mV,0-60mV,0.2-1V(100-500mV),-20 -+20mV(0-10V) -5V- +5V(0-50V), -100 - +100mV(2-10V) Linear Resistor:0-80 Ohm, 0-400 Ohm
Output	Voltage pulse to drive SSR
Control action	Heating , Cooling
Response time	Less than 0.5S (configurable)
Accuracy	0.2%FS+- 0.1C(Cu50 cooper resistor compensation or ice point compensation) 0.2%FS+0.2C (TC input and internal compensation)
Temperature drift	Less than 0.01%FS 0C (Typical value is 50ppm/0C)
Resolution	10C or 0.10C(automatically change to 10C when the temperature is higher than 999)
Display	Dual line - four digit - LED display
Decimal points	Configurable for all inputs
Control Method	ON/OFF AI MPT with auto tuning, adopting fuzzy logic PID algorithm
Auto/Manual Control	Auto/manual bump less transfer from front panel
Auto-tuning	Auto-tuning and manual tuning available
Alarm Mode	Absolute value high limit, Absolute value low limit, Deviation high limit alarm, Deviation low limit alarm.

Manual

Plug & Play Programmable Ramp & Soak PID Temperature Controller Box with SSR Relay Circuit Breaker 20A Heat Sink and Ceramic Thermocouple 1300C Probe Sensor for Kiln Pottery Glass Annealing

Product Code:CKP-PID-RS-P&P20
Availability:In Stock

USD248.00

Qty

0 reviews / Write a review